Need help?Do you have a question about the Xylem Goulds ResiBoost RB111512 and is the answer not in the manual?
General| Brand | Xylem |
|---|---|
| Model | Goulds ResiBoost RB111512 |
| Category | Controller |
| Language | English |
Operator must be aware of safety precautions to prevent physical injury. Read manual carefully before use.
Emphasizes observing accident prevention, using suitable equipment, and adhering to local codes for installation.
Stresses connecting the ground (earth) connection before making any other electrical connections.
Instructs to turn off power, lockout, and wait before making electrical connections.
Describes the buttons (POWER, ERROR, PUMP, AUTO, MAN, MENU, ENTER) and display elements of the controller.
Guides through checking connections, powering up, autotest, and initial programming of the controller.
Describes general alarm behavior, fault LED indication, and manual alarm reset procedures.
Provides a step-by-step guide for manually resetting alarms and restarting the pump after an event.
Details troubleshooting for the 'No Water/Loss of Prime/Dry Pump' alarm (R1), its causes, and solutions.
Explains the Overcurrent alarm (R2), controller reaction, causes, and troubleshooting steps.
Details the Open Lead alarm (R3), its causes, and required manual alarm reset procedures.
Describes the Minimum Pressure alarm (R4), causes, and troubleshooting for low system pressure.
Explains the Pressure Sensor Fault alarm (R5), controller reaction, and troubleshooting for sensor issues.
Details the Over Temperature alarm (R6), its causes, and troubleshooting for power module overheating.
Explains the Short Circuit alarm (R7), controller reaction, causes, and warnings about repeated exposure.
Details the Over Voltage alarm (R8), causes, and troubleshooting steps for high input voltage.
Explains the Under Voltage alarm (R9), causes, and troubleshooting for low input voltage.
Lists key programming parameters to check during system startup, like motor current (R) and pressure setpoint (SP).
Provides step-by-step instructions for setting the system's operating pressure (Pressure Setpoint) via the BASIC menu.
To Next Page