Xylem Goulds ResiBoost RB111512 - BASIC MENU (MB) Parameters

Parameter Description
A4 Total number of times the A4 (Minimum Pressure) alarm
has been triggered.
A5 Total number of times the A5 (Pressure Sensor Fault)
alarm has been triggered.
A6 Total number of times the A6 (Over Temperature) alarm
has been triggered.
A7 Total number of times the A7 (Short Circuit) alarm has
been triggered.
A8 Total number of times the A8 (Overvoltage) alarm has
been triggered.
A9 Total number of times the A9 (Undervoltage) alarm has
been triggered.
Press (6) to view values greater than 99.
Example:
Total operating hours HF = 1250.
+
+
+
+
+
…
HF
12 50
Figure 8: Total operating hours
Total alarm A2 = 102.
+
+
+
+
+
+
+
+
...
A2 A3
01 02
...
Figure 9: Total alarm
RESET LOGS: Scroll to A9 log and then press. and hold (4) to exit the menu. This
resets the counter and alarm log.
5.3 Programming
The controller has two parameter menus that are accessed with a combination of keys:
• BASIC MENU (MB)
• ADVANCED MENU (MA)
NOTICE:
• The controller is delivered already programmed with the default values. Edit the values
according to the type of pump and system.
• If the controller was supplied from the factory with a pump, it has been programmed at
the factory for operation with the pump.
• Incorrect configuration can damage the pump, motor and/or system.
5.3.1 BASIC MENU (MB) parameters
Refer to Figure 7: User interface on page 16 for an explanation of the buttons on the user
interface.
Use the steps below to enter and navigate the BASIC MENU.
5 System Description
ResiBoost INSTRUCTION MANUAL 19