Need help?Do you have a question about the Xylem HYDROVAR HV 2.022 and is the answer not in the manual?
General| Type | Pump Controller |
|---|---|
| Model | HYDROVAR HV 2.022 |
| Frequency | 50/60 Hz |
| Output Power | 2.2 kW |
| Motor Power | 2.2 kW |
| Protection Class | IP55 |
| Ambient Temperature | -10°C to +40°C |
| Storage Temperature | -20°C to +60°C |
| Humidity | 5% to 95% non-condensing |
| Enclosure | Wall-mounted |
| Control Method | Sensorless Vector Control |
| Communication Protocols | Modbus, BACnet |
Details the different operational modes including Actuator and Controller.
Provides specifications on ambient temperature, storage temperature, humidity, air pollution, altitude, protection class, and certifications.
Details EMC requirements for first and second environments and relevant standards.
Discusses protective measures like earthing, RCDs, and circuit breakers for safe electrical installation.
Explains how to ensure EMC compatibility through proper cable installation and grounding.
Lists recommended cable types for motor, control, and signal connections to ensure EMC compatibility.
Details the wiring and connection points on the HYDROVAR MASTER/SINGLE Inverter.
Details the MASTER Inverter control card, its connections to the power unit, and optional boards.
Lists control terminals on the control card, including digital and analogue I/O.
Shows the display and control panel of the MASTER/SINGLE Inverter, including indicator LEDs.
Explains the functions of each push button on the MASTER/SINGLE Inverter control panel.
Sets the operation mode to Controller, the default for single inverter use.
Sets operation mode for controlling multiple pumps via relay card.
Sets operation mode for multi-pump systems via RS485 interface.
Sets operation mode for synchronized multi-pump systems running at same frequency.
Sets operation mode for single pump control using external speed signals.
Provides an overview of the status of connected units, indicating running or deactivated states.
Enables selection of a specific unit to check its status, motor hours, and last failures.
Stores and displays all errors, including failure text, date, and time.
Selection of the operation mode for the HYDROVAR, such as Controller, Cascade Relay, etc.
Clears the error memory for a selected unit or all units.
Lists errors indicated by the red LED on BASIC Inverters and their probable causes.
Details errors shown on the MASTER/SINGLE Inverter display, including reset methods.
Lists internal errors, their messages, probable causes, and reset procedures.
To Next Page