Xylem Lowara Micro PRESFIX User Manual (English)

To Next Page

Micro PRESFIX

Pressurisation Set

Operating, Installation and Maintenance Instructions

EC Declaration of conformity

Xylem Water solutions UK Ltd declare that the Micro Presfix pressurisation set conforms to the:

Requirements of the Machinery Safety Directive 2006/42/EC.

Electromagnetic compatibility (EMC) Directive 2014/30/EU

Conforming to the UK Health & Safety Requirements 2008 No.1597

Water supply (Water fittings) regulations 1999

Code of practice for heating and chilled water systems BS7074 (parts 1, 2 & 3)

Signed: Position: Engineering manager Date: 13-01-2017

Clive Willmott

Introduction

This leaflet contains information to enable the safe installation and operation of the products mentioned above.

The following instructions must be read and understood by all persons responsible for the installation, operation

and maintenance of this product.

Warning Symbols

Safety instructions where noncompliance would affect safety.

Safety instructions where electrical hazard is involved.

Safety instructions where noncompliance could cause damage to the equipment.

Instruction for safe use

This product has been designed for the pressurisation of sealed heating, chilled water and

closed-condenser water systems to the operating conditions shown.

This product should not be installed until this leaflet has been studied carefully.

Handling, transportation and installation of this equipment should only take place with the proper use

of lifting equipment.

This product must be stored in a frost-free dry environment.

Noise Emissions

This equipment operates at a noise level lower than: 70dBA.

Protection degree: IP54

Ambient temperature: 4-30°C

Maximum system operating pressure: 7 bar

O&M Micro Presfix_Layout 1 29/03/2017 11:15 Page 1

Need help?

Do you have a question about the Xylem Lowara Micro PRESFIX and is the answer not in the manual?

Xylem Lowara Micro PRESFIX Specifications

General