Drive system
Installation and disassembly
• → 16
• → 18
• → 15
• → 18
Job order Quantity Remark
1 2
2 1
3 1
9
As shown in the figure, the motor has two M16-1.5 nuts and two M6*12 bolts fixed on the vehicle. After
disassembly, the motor can be removed;
There are 12 threaded holes on the end cover of the motor (the outlet end of the motor), which are directly
connected with the magnetic guide ring through the bolts of the inner hexagon.
In the process of disassembly, the power should be cut off first, then pull out the U, V, W three cables and
the Hall wire harness, and finally use the related tools to carry out mechanical disassembly and assembly.
Seat cushion
Back backrest
Footrest
Side cover
Left/right flat fork guard plate
Braking drum
Rear wheel (motor)
Job name/part name
To Next Page
Loading...
