Yaesu FT-950 - MENU MODE LIST - AGC Group; Display Group; Agc Fst Dly; Agc MID Dly

Page 108 FT-950 OPERATING MANUAL
AGC GROUP
001 AGC FST DLY
Function: Sets the delay time for the AGC FAST mode.
Available Values: 20 ~ 4000 msec (20 msec/step)
Default Setting: 300 msec
002 AGC MID DLY
Function: Sets the delay time for the AGC MID mode.
Available Values: 20 ~ 4000 msec (20 msec/step)
Default Setting: 700 msec
003 AGC SLW DLY
Function: Sets the delay time for the AGC SLOW mode.
Available Values: 20 ~ 4000 msec (20 msec/step)
Default Setting: 3000 msec
DISPLAY GROUP
004 DISP COLOR
Function: Selects the Display color when the optional Data
Management Unit (DMU-2000) is connected.
Available Values: bL1/bL2/bL3/ub1/ub2
Default Setting: bL1 (COOL BLUE)
bL1: COOL BLUE
bL2: CONTRAST BLUE
bL3: FLASH WHITE
ub1: CONTRAST UMBER
ub2: UMBER
ADVICE:
If the optional DMU-2000 Data Management Unit is not
connected, this adjustment has no effect.
005 DISP DIM VFD
Function: Setting of the display brightness level.
Available Values: 0 ~ 15
Default Setting: 8
006 DISP BAR SEL
Function: Selects one of three parameters to be viewed
on the Tuning Offset Indicator.
Available Values: CLAr/C-tn/u-tn
Default Setting: C-tn
CLAr: Displays relative clarifier offset.
C-tu: Displays relative tuning offset between the incom-
ing signal and transmitted frequency while in CW
operation.
u-tn: Displays the peak position of the optional μ-TUNE
filter.
007 DISP PKH S
Function: Selects the peak hold time of the S-meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
008 DISP PKH PO
Function: Selects the peak hold time of the PO meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
009 DISP PKH ALC
Function: Selects the peak hold time of the ALC meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
010 DISP PKH ID
Function: Selects the peak hold time of the ID meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
MENU MODE