configurations selected, the frequency display toggles between the frequency and tag name to identify that an
alternate DG-ID is selected.
FTM-3200DE, FTM-3207DE
Press and hold the P2 key on the microphone. The DG-ID memory number at the bottom right of the screen
blinks. Rotate the DIAL knob or DG-ID memory number to 01. Press the P2 on the microphone. The transmit DG-
ID number blinks. Rotate the DIAL knob to set the transmit DG-ID to 10. Press and hold P2 key to return to normal
screen. To recall the DG-ID registered in a DG-ID memory, press P1 key on the microphone and rotate the DIAL
knob to select the DG-ID memory 01. Press the PTT switch to exit to normal screen.
For other Yaesu Fusion radios, please consult your documentation.
Why don’t I see the DG-ID setting screen on my Yaesu Fusion radio?
Please check you are using the latest firmware for your radio, by visiting the appropriate radio page at
www.yaesu.com
Minimum Firmware Version for DG-ID
MAIN V2.02, SUB V2.01, DSP V4.30
MAIN V1.00, SUB V1.00, DSP V7.01
MAIN V2.00, PANEL V2.00, DSP V4.15
MAIN V3.00, TFT V3.00, DSP V4.15, DSP V1.11
MAIN V2.00, TFT V2.00, DSP V4.15, DSP V1.11
If you find an error in this document, please email G6NJM@SkySmiths.com
Thanks to Karl Brazier (G7AFT) for adding content and firmware to this document, and Dorian Woolger (2E0FSI)
for FT-991A information.
Document produced by G6NJM, 17-09-19, v1.4
To Previous Page
Loading...
