59
Using the Memory
Using the Memory
Split memory
A separate transmit frequency may be registered to a memory channel to which a
receive frequency has already been registered.
1 In VFO mode, select the transmit frequency to be registered.
2 Press and hold for over one second.
The MEMORY WRITE screen appears.
The entered transmit frequency automatically
appears on the next blank memory channel.
3 Rotate the DIAL (if necessary) to select the memory
channel to which the transmit frequency is to be
registered.
Tip Pressing briefly skips memory channels in steps
of 100 memory channels.
4 Press , (
appears on the upper side).
The confirmation screen appears.
5 Rotate the DIAL to select [OK?], then press .
Registers the transmission frequency, then displays
the memory mode screen.
Tip appears on the left side of a memory channel when
a separate transmit frequency is registered. Also, when
such a memory channel is selected,
appears on the
screen.
To Next Page
Loading...
Need help?
General
