R
www.yankong.com MS-S3 V2.1 User Manual
21 03/06/2019
7.2 Fault analysis and solution
Error
code
Error
name
Causes Solution
Err-2
Overvoltage
protection
① The driver power input
voltage exceeds the
specified value.
② The regenerative energy is
too large when the drive is
braked.
③ Drive failure (loop failure)
①
Use correct voltage
②
Increase the acceleration /
deceleration time, reduce
load or increase the value
of PA-28.
③
Replace a new drive
Err-5
Overcurrent
protection
①
Motor current line A+, A-,
B+, B- short circuit.
②
Drive failure (loop, fail parts).
③
Motor burned out.
①
Check if the motor current
line is short-circuited, and
if there is a burr on the line.
Connect the current lines
correctly.
②
Replace a new drive
③
Replace a new motor
Err-8
Motor phase
wiring
connection
wrong
protection
①
Motor current line A+, A-,
B+, B- line sequence error.
②
Motor current line A+, A-,
B+, B- short circuit.
①
Verify that the motor
current line is properly
connected as required.
②
Check if the motor current
line is shorted.
Err-4
Encoder
error
①
Encoder feedback interface
is loose, off-line,
disconnected, shorted.
②
The motor components are
damaged.
③
Drive failure.
①
Check that the encoder
feedback cable is correct
and connected reliably.
②
Replace a new motor
③
Replace a new drive.
Err-7
Tracking
tolerance
error
protection
①
Motor current line A+, A-,
B+, B- is not reliably
connected, or the line
sequence is wrong.
②
The load is too large, the
acceleration/deceleration
time is too short, or the
motor selection is not
suitable.
③
The motor has an
electromagnetic brake and
the electromagnetic brake is
not opened as required.
④
The motor has an
electromagnetic brake, but
①
Verify that the motor
current line is correctly and
reliably connected as
required.
②
Increase the value of PA-9
appropriately without
affecting the processing
requirements of the
equipment.
③
Properly extend the
acceleration and
deceleration time to
reduce the load and
reduce the speed.
④
Check that the motor
To Next Page
Loading...