Yale UNI Series - User Manual

Installation Instructions
80-9303-2214-010 (07-08)
Components:
3300 Series Standard
Narrow Plastic Cover
w/ 1639 Pinion Cap
3500 Series
Standard Plastic
Cover with Insert
Optional
Full Metal Cover
with Cover Screws
3500M Series
Optional Architectural
Metal Cover
3500MA Series
Optional
Architectural Plastic
Full Cover w/ Insert
3500A Series
Power
Adjustment
Shaft
2 Sex-nuts
Rod Unit
(Arm Number Stamp)
Main Arm
Screw
Rod Screws
Slide unit
Holder Control
S
Optional
Thru-Bolt
&
Grommet Nuts
An incorrectly installed or improperly
adjusted door closer can cause property
damage or personal injury. These instructions
should be followed to avoid the possibility
of misapplication or misadjustment.
CAUTION
!
!
!
!
Always use template covering door-opening-angle desired,
correct door-thickness and frame-reveal, and door-hanging-
hardware being used. Template dimensions in these
instructions (page 2) cover frame reveals to 7-3/8” (187mm)
in opening with 1-3/4” (44mm) thick doors hung on 4-1/2”
(114mm) wide template-hinges (figure 2), 3/4” (19mm)
offset-pivots (figure 2) or center-pivots (figure 3).
Check hand of door: right or left (see figure 5, page 3). Make
sure that door opens the full angle desired and latches
without any binding action or interference. Note that hold-
open units will require that door swing five (5) degrees past
hold-open point, to dead-stop position.
It is suggested that sex-nuts and bolts be used to mount
arm-foot and to mount closer to flush partitions.
Top Jamb Unitrols are supplied with arm rod units according
to frame-reveal. An arm number is stamped on the arm
rods, as shown on Figures 2 and 3 (page 2).
UNI Stop/Holder
The closing force for these series door
closers is adjustable from a size 1 to a size 6,
as outlined in ANSI Standard A156.4. When
these series of door closers are installed and
adjusted to conform to ADA reduced opening
force requirements (5 lbs max.) for interior
doors, they may not have adequate closing
force to reliably close and latch the door. Power adjustments
charted on Page 4 are recommended where possible, to
ensure proper door control.
Power Adjustment Chart for TJ3301/TJ3501, TJ3311/TJ3511 ONLY
NOTE: Maximum of 20 turns (360°) of Power Adjustment Shaft.
Closer is shipped set at 10 turns.
4
7
8
9
7
8
10
12
Interior
Door
Exterior
Door
DOOR
32”
(0.85M)
36”
(0.90M)
42”
(1.00M)
48”
(1.20M)
MAXIMUM DOOR SIZE
Number of Turns Required
is identified with a "DL" suffix to the series number.
Multi-Size1thru6
2, 3, 4, 5 or 6
Multi-Size1thru6
Series No.*
UNI TJ3301
UNI TJ3500
UNI TJ3501
UNI TJ3311
UNI TJ3510
UNI TJ3511
* These series have a DELAYED ACTION CLOSING option available that
Non Hold Open Hold Open Sizing
UNI TJ3300 2, 3, 4, 5 or 6UNI TJ3310
Power Adjust
Use 5/16” Socket or Adjustable Wrench
for this Adjustment
+
-

Summary

Yale Uni Stop;Holder Installation

Power Adjust

Guide for adjusting the power of UNI TJ3301/TJ3501 and TJ3311/TJ3511 series closers.

Components

Lists and diagrams of the various parts included with the Yale Uni Stop/Holder.

Installation Sequence

Preparation for Fasteners

Chart detailing fastener types and recommended drill sizes for installation.

Mounting and Assembly Steps

Step-by-step instructions for mounting the closer, arm assembly, and connecting rod.

Adjustment Instructions

Closing Power and Speed Adjustment

Instructions for adjusting closing power, latch, sweep, and optional delay speed.

Hydraulic Control and Backcheck

Details on adjusting hydraulic controls for opening cycle and backcheck range.

Installation of Covers

Procedures for installing various types of covers (full, narrow, architectural).

Door Holder Option

Instructions for operating and adjusting the hold-open feature.

Yale UNI Series Specifications

General

User PIN Code	Up to 100
RFID Card Capacity	Up to 100
Power Supply	4 x AA Batteries
Auto Lock	Yes
Mobile App	Yale Access App
Lock Type	Mortise Lock
Authentication	PIN Code, RFID Card
Back Body Dimensions	85 x 85 x 25 mm
Battery Life	Approx. 12 months
Emergency Power	9V Battery
Communication Protocol	Bluetooth
Backset	60 mm