PIN Code Management (With Network Module – Up to 250 Users)
User Type User Name User # PIN Code
Master
User
User
User
User
User
User
User
User
User
User
User
User
User
User
User
Resetting Lock to Factory Default
When lock is reset to factory defaults all user codes (including the Master code*) are deleted and all PIN programming features are reset to original default
settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior escutcheon to access the reset button.
3. The reset button (see image at right) is located beside the cable connector. PCB
4. While pressing the reset button (minimum of 3 seconds) reinstall batteries. Release reset button.
5. Replace battery cover.
Upon reset, Master Code creation is the only option PIN available and must be performed prior to any other programming of the lock.
Factory Settings
To Next Page
Loading...
