IMPORTANT: the batteries be removed prior must to removing and/or inserting the network module:
Remove battery cover.
Remove batteries.
Remove and/or insert network module.
Reinstall batteries.
Replace cover.
Enrolling/Unenrolling the Network Module:
This device is a security enabled ZigBee product that is able to use encrypted ZigBee messages to communicate to other security enabled ZigBee products.
This device must be used in conjunction with a Security Enabled ZigBee Controller in order to fully utilize all implemented functions. This product can be
operated in any ZigBee network with other ZigBee certified devices from other manufacturers. All non-battery operated nodes within the network will act as
repeaters regardless of vendor to increase reliability of the network.
To Enroll/Add the Module (Inclusion Mode):
Enter the 4-8 digit Master code followed by the key.
Press the key followed by the key.
Press the key followed by the key.
To Unenroll/Remove the Module (Exclusion Mode)
Enter the 4-8 digit Master code followed by the key.
Press the key followed by the key.
Press the key followed by the key
FCC:
Contain : U4A- 0 FCC ID YRHCPZW FM
Model: 2- YRMZW US
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the Rules. These limits are designed to
provide FCC reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with radiation exposure FCC limits set forth for an uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This device complies with Part 15 of the rules. FCC Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not
expressly approved by manufacturer could void the user’s authority to operate the equipment.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
Industry Canada:
IC YRHCPZB FM : 6982A- 0
Model: 2 YRMZB
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: 1) this device may not cause
interference, and
2) this device must accept any interference, including interference that may cause undesired operation of the device.
To Next Page
Loading...
