27
P/N YRD604-KF-ZW-0044 Rev A
Entry code will not register.
· If low battery indicator is lit, replace batteries*.
· Verify that your entry code consists of 4 to 8 digits.
· Make sure you are using different entry codes for different users.
· Entry code must be entered while the keypad is active (tap on the Yale logo to wake it up and enter
the entry code within 5 seconds).
Upon entering an entry code and pressing the
Check key, the lock displays “Invalid Code”
error or lock times out without responding.
· Verify entered code is a valid, previously programmed, 4 to 8 digit code.
· Turn off vacation mode from the lock’s programming menu. This can only be done using the
programming code (page 22).
Upon entering an entry code and pressing the
Check key, lock responds “Wrong Number of
Digits”.
· The digits entered were incorrect or incomplete. Re-enter the correct code followed by the Check
key.
Deadbolt does not extend when locking the
door with the keypad.
· Lock was not handed properly. Find the setting called “Lock Handing” to fix this issue.
Lock operates but makes no sound.
· Turn on the volume from the lock’s programming menu. This can only be done using the
programming code (page 22).
Lock Operations Troubleshooting
To Next Page
Loading...
