Need help?Do you have a question about the Yamaha CR-220 and is the answer not in the manual?
General| Brand | Yamaha |
|---|---|
| Model | CR-220 |
| Category | Stereo Receiver |
| Language | English |
Handle the unit carefully and avoid exposure to sunlight, heat, cold, moisture, or dust.
Use only specified cleaning methods and consult authorized service for repairs.
Follow operating instructions, use AC outlets appropriately, and refer to the manual.
Check troubleshooting before service calls and prevent hazards by avoiding moisture.
Controls the unit's power supply. Set volume to '0' before switching.
Allows headphone listening without muting speakers.
Selects speaker output (A, B, or both) or turns speakers off.
Adjust bass and treble frequencies with specific turnover points.
Includes LOUDNESS, VOLUME, and BALANCE controls for audio adjustment.
Features TUNING control, INPUT SELECTOR, and TAPE monitor switch.
Includes FM/AM tuning scale, signal meter, and LED indicators.
Terminals for 75Ω coaxial and 300Ω balanced FM antenna connections.
Includes a connecting-bar for AM and terminals for external AM antenna and ground.
Details for connecting speaker sets A and B, including impedance.
Covers PHONO, AUX, TAPE PB/REC OUT, and GND terminals for audio sources.
Describes AC outlets for accessories and the main power line connection.
Guidelines for connecting FM antennas, including types and placement.
Instructions for stripping and connecting coaxial cable to 75Ω terminals.
Describes AM reception setup, including connecting-bar installation.
Describes the FM tuning meter, AM signal meter, and their use.
Covers tuning FM stations, stereo reception, and FM muting features.
Instructions for connecting external AM antennas and tuning AM stations.
Steps for connecting a turntable, including power, audio, and ground connections.
Explains the continuous loudness control for maintaining tonal balance at low volumes.
Details on bass/treble tone controls and the built-in subsonic filter.
Illustrates how to connect a tape recorder to the CR-220 rear panel.
Procedure for playing back tapes using the TAPE MONITOR switch.
Guidance on setting levels and making recordings onto a tape deck.
Details output power, distortion, input sensitivity, and frequency response.
Covers tuning range, sensitivity, selectivity, and signal-to-noise ratio for FM.
Includes general details, power, dimensions, weight, and AM specifications.
Provides detailed distortion (THD, IMD) and stereo separation figures.
Lists AM section sensitivity/selectivity and general unit details like power, dimensions, and weight.
Diagnoses and resolves common audio issues like no power, no sound, or poor response.
Addresses problems with speaker output, sound cutting out, and hum.
Helps fix poor bass response, distorted stereo imaging, and exaggerated frequencies.
Solves hum, crackling, and noise problems during AM reception.
Addresses stereo monaural playback, crackling interference, and hiss on FM stations.
Resolves distorted sound from local stations and faint crosstalk in stereo.
To Next Page
