Need help?Do you have a question about the Yamaha CR-200E and is the answer not in the manual?
Diagram and labeling of the front panel controls and indicators.
Diagram and labeling of the rear panel for the general model.
Diagram and labeling of the rear panel for the Australian model.
Diagram and labeling of the rear panel for Europe and B.S. models.
Schematic diagram detailing differences for the Australian model.
Schematic diagram detailing differences for Europe and B.S. models.
Diagram and labeling of the front panel controls and indicators.
Diagram and labeling of the rear panel for the general model.
Diagram and labeling of the rear panel for the Australian model.
Diagram and labeling of the rear panel for Europe and B.S. models.
Schematic diagram detailing differences for the Australian model.
Schematic diagram detailing differences for Europe and B.S. models.
General| Tuning Range | FM, MW |
|---|---|
| Damping Factor | 30 |
| Input Sensitivity (MM) | 2.5 mV |
| Input Sensitivity (Line/AUX/DIN) | 150 mV |
| Signal to Noise Ratio (MM) | 70 dB |
| Signal to Noise Ratio (Line/AUX/DIN) | 80 dB |
| Output (Line) | 150 mV |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion (THD) | 0.5% |
| Inputs | Phono, Aux, Tape |
| Outputs | Tape |
| Speaker Load Impedance | 4-16 ohms |
To Next Page
