2. Attach the XP80 snare pad to the rod, and then tighten the clamp bolt to secure
the snare pad.
3. Loosen bolts A to D as shown below to adjust the height and angle of the snare
pad. When correctly positioned, be sure to securely retighten the bolts before
proceeding to the next step.
Tom pads
1. As with the snare pad, attach a wing bolt to each of the three tom pads and
provisionally tighten (by five or six turns).
2. Push each of the tom pads onto one of the rack’s tom holders. Each time,
ensure that the tom holder’s rod is fully inserted into the tom pad’s mounting
hole, and then tighten the bolt to secure the pad in place.
3. Loosen bolts A to C as shown below to adjust the height and angle of each tom
pad. When correctly positioned, be sure to securely retighten the bolts before
proceeding to the next step.
To Next Page
Loading...
