Assembling the kick pad
1. If a drum mat (sold separately) is not available, lay a sheet of cardboard on the floor to
prevent it from being scratched.
2. Remove the four wing bolts, spring washers, and flat washers from the kick pad frame, and
line up each set nearby in the order of removal.
3. Join the base to the frame as shown on the right, and then secure it in place by assembling
the wing bolts, spring washers, and flat washers removed in the previous step from the base
side.
NOTE
For details on assembling the foot pedal (sold separately), refer to the “Setting Up” in the
KP65 Owner’s Manual.
4 Arrange the hi-hat controller and the kick pad as shown in Example of
standard assembly on the other side of this sheet.
NOTICE
To Next Page
