in place.
5. With the stopper making full contact with the bottom surface of the bolt cover
as shown below, tighten the stopper’s key bolt using the drum key.
6. Place one of the felt pads removed in Step 2 on the cymbal holder.
7. Mount the pad on the cymbal stand. Lower the pad into place with the cymbal
holder’s shaft passing through the central hole. When mounted, the stopper’s
pin should rest inside the pad’s smaller hole.
* If you were to play your cymbal pad without the stopper’s pin positioned well
inside the smaller hole, the pad could rotate, causing the pin to be pulled out. It
is very important, therefore, to ensure that the stopper is secured as shown in
Step 5 above.
8. Assemble the other felt pad removed in Step 2 to the cymbal holder.
9. Tighten the wing nut to secure the pad to the cymbal holder.
To Next Page
