2. Push the module holder into the holder clamp and tighten the clamp bolt to
secure it in place.
Each cymbal and hi-hat pad
1. Using the drum key, loosen the stopper’s key bolt.
2. Remove the wing nut, the two felt pads, and the bolt cover from the cymbal
holder.
3. Place the stopper on the cymbal holder.
* If the key bolt was not sufficiently loosened in Step 1 above, it may not be
possible to pass the stopper over the cymbal holder’s shaft. In such a case,
loosen the key bolt as much as possible without removing it.
4. Replace the bolt cover.
* Turn the bolt cover to tighten it onto the threaded section and firmly secure it
To Next Page
