Operation
59
The signal transmission range of the re-
mote control transmitter varies depending
on the mounting position of the receiver. To
operate the Yamaha Security System cor-
rectly, use the transmitter as close as pos-
sible from the receiver.
If the Yamaha Security System does not
operate correctly, repeat the activating
procedure.
2. Place the remote control lever in “ ”
(neutral).
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
3. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
4. Turn the main switch to “ ” (on).
ON
STARTOFF
ON
STARTOFF
ZMU05828
U6EK71E0.book Page 59 Monday, December 8, 2014 10:28 AM
To Next Page
Loading...
