4-9
GB
EMU01754¯
1) Wash the motor body using fresh water.
(Refer to “MOTOR EXTERIOR”.)
2) Remove the grommet
1
.
3) Place a container under the carburetor
drain hole to catch the gasoline, and
then loosen the drain screw.
4) Place the fuel cock in the CLOSED posi-
tion.
5) Tighten the air vent screw.
6) Drain the cooling water completely out
of the motor.
7) Clean the body thoroughly.
U69M71A0.book Page 9 Thursday, January 30, 2003 2:26 PM
To Next Page
Loading...
