Operation
56
turn the main switch to “ ” (off).
2. After stopping the engine, disconnect
the fuel line if there is a fuel joint on the
outboard motor.
3. Tighten the air vent screw on the fuel
tank cap (if equipped).
4. Remove the key if the boat will be left un-
attended.
5. When you leave your boat, set the
Yamaha Security System to the lock
mode by pressing the lock button of the
remote control transmitter. Short beep
will sound once when locking the securi-
ty system. The lock mode is selected
only when the main switch is in the “ ”
(off) position. For further information,
see page 18. WARNING! Do not set
the Yamaha Security System in the
lock mode when you stop the engine
at offshore.
[EWM02151]
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to “ ” (off).
6BG-9-78-1E0.book 56 ページ ２０１４年１１月２０日 木曜日 午後３時３分
To Next Page
Loading...
