Trouble Recovery
91
nents for damage. Also, check the boat
for damage.
3. Whether damage is found or not, return
to the nearest harbor slowly and careful-
ly.
4. Have a Yamaha dealer check the out-
board motor before operating it again.
EMU30684
Replacing fuse
If a fuse has blown, open the fuse holder and
remove the fuse with a fuse puller. Replace
it with a spare one of the proper amperage.
EWM00632
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29513
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit , the engine can be tilted
manually.
1. Loosen the manual valve screw by turn-
ing it clockwise until it stops.
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it counterclockwise.
1. Fuse (20 A 2, 30 A)
2. Spare fuse (20 A 2, 30 A)
3. Fuse puller
1. Fuse puller
1. Manual valve screw
6BG-9-78-1E0.book 91 ページ ２０１４年１１月２０日 木曜日 午後３時３分
To Next Page
Loading...
