Trouble Recovery
93
6. Drain the water in the filter cup by soak-
ing it up with a rag.
7. Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
[ECM01971]
8. Connect the water detection switch cou-
pler securely until a click is heard.
9. Fasten the water detection switch lead
with the holder.
10. Install the top cowling.
11. Start the engine and make sure that the
water separator-alert indicator remains
off. Have a Yamaha dealer inspect the
outboard motor after returning to port.
EMU29543
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started manually with
an emergency starter rope. However, the en-
gine cannot be started manually if the battery
voltage is low. If the battery is discharged to
9 volts or below, the electric fuel pump will
not operate.
EWM01023
Use this procedure only in an emergen-
cy to return to the nearest port for re-
pairs.
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
could result in an accident.
Attach the engine shut-off cord to a se-
cure place on your clothing, or your
1. Filter cup
2. Water detection switch lead
1. Water detection switch coupler
1. Holder
6BG-9-78-1E0.book 93 ページ ２０１４年１１月２０日 木曜日 午後３時３分
To Next Page
Loading...
