Basic components
28
NOTE:
The tachometer unit shows various kinds of
information according to the setting made us-
ing the “” (set) and “” (mode) buttons.
For details, see the attached operation manu-
al.
Pre-operation checks
Place the remote control lever in neutral and
turn the main switch to “” (on).After all the
displays come on and the total hour display
comes on, the gauge will change to normal
operation. If the buzzer sounds and the water
separator-warning indicator blinks, consult
your Yamaha dealer immediately.
NOTE:
To stop the buzzer, press the “” (set) or
“” (mode) button.
Low oil pressure warning
When the engine oil pressure drops too low,
the low oil pressure-warning indicator will start
to blink, and the engine speed will automati-
cally decrease to about 2000 r/min.
Stop the engine immediately if the buzzer
sounds and the low oil pressure-warning indi-
cator blinks. Check the engine oil quantity and
replenish oil if necessary. If the warning de-
vice has activated while the appropriate en-
gine oil quantity is maintained, consult your
Yamaha dealer.
CAUTION:
ECM01600
Do not continue to run the engine if the
low oil pressure warning device has acti-
vated. Serious engine damage will occur.
Overheat warning
If the engine temperature rises too high while
cruising, the overheat-warning indicator will
start to blink. The engine speed will automati-
cally decrease to about 2000 r/min.
ZMU05430
ZMU05431
ZMU05421
U6P272E0.book Page 28 Friday, March 16, 2007 1:22 PM
To Next Page
