INSP
REG
3-33
3.Replace:
• blown fuse 햲
a.Set the main switch to “OFF”.
b.Install a new fuse of the correct amperage.
c.Set on the switches to verify if the electrical
circuit is operational.
d.If the fuse immediately blows again, check the
electrical circuit.
Fuse
main circuit : 7.5 A
Never use a fuse with an amperage rating
other than that specified. Improvising or using
a fuse with the wrong amperage rating may
cause extensive damage to the electrical
system, cause the lighting and ignition
systems to malfunction and could possibly
cause a fire.
4.Install:
•battery cover
Refer to "BATTERY COVER AND LOWER
COVER"
CHECKING THE FUSE/
REPLACING THE HEADLIGHT BULB
EAS00182
REPLACING THE HEADLIGHT BULB
1.Disconnect:
•front cover 햲
Refer to "FRONT COVERS"
2.Detach:
•headlight bulb holder 햲
3.Remove:
•headlight bulb 햳
Since the headlight bulb gets extremely hot,
keep flammable products and your hands
away from the bulb until it has cooled down.
WARNING
WARNING
햳
햲
햲
햳
To Next Page
Loading...
Need help?
General