MOX6/MOX8 Owner’s Manual
Quick Guide
33
The Solo function is the opposite of Mute, and lets you instantly
solo a specific Part and mute all others.
1 Press the [SOLO] button.
The SOLO lamp lights, indicating that Solo is enabled.
2 Press any of the Number [1] – [4] buttons.
The lamp of the pressed button will flash and only the
corresponding Part will be sounded. Press any other Number
button to change the solo Part.
NOTE
You can exit from this status by pressing the [TRACK] button
or [PERFORMANCE CONTROL] button.
Using the Arpeggio function
The Arpeggio function lets you trigger rhythm patterns, riffs
and phrases using the current Voice by simply playing notes
on the keyboard. In the Performance mode, each of four
Arpeggio types is assigned to each of four Parts. This means
four Arpeggio types can be played back simultaneously. Try
selecting different Performances and check out the various
Arpeggio types.
NOTE For details about Arpeggio, see the “Reference Manual” PDF
document.
Since the preset Performances already have their own
Arpeggio types pre-assigned, you can play the Arpeggio by
selecting the desired Performance, turning on the ARP [ON/
OFF] button, then pressing any note. Instructions on using
Arpeggio are basically the same as in the Voice mode.
You can turn Arpeggio playback on or off for each Part of the
Performance as described below.
1 Press the [PERFORMANCE CONTROL] button.
The [PERFORMANCE CONTROL] lamp lights, indicating
that Arpeggio playback for each Part can be turned on/off.
2 Pressing each of the Number [5] – [8] buttons
toggles Arpeggio playback on and off for each
Part.
If any of the [5] – [8] lamps is turned off, the Arpeggio
playback of the corresponding Part is muted.
You can turn the Arpeggio Hold parameter on /off or on/sync-
off for each Part of the Performance as described below.
When the Arpeggio Hold parameter is set to “on,” Arpeggio
playback continues even if the note is released.
NOTE The Arpeggio Hold parameter is in the [F3] MAIN display of the
Arpeggio Edit display. For details on this parameter, see the
Reference Manual.
1 Press the [PERFORMANCE CONTROL] button.
The [PERFORMANCE CONTROL] lamp lights, indicating
that Arpeggio Hold for each Part can be turned on/off or on/
sync-off.
2 Pressing each of the Number [13] – [16] buttons
toggles the Arpeggio Hold parameter on and off
for each Part.
If any of the [13] – [16] lamps is turned on, the Arpeggio
Hold parameter of the corresponding Part is turned on.
Soloing a specific Part
1
2
Turning Arpeggio playback on/off for each
Part
Turning the Arpeggio Hold parameter on/off
for each Part
To Next Page
Loading...
Need help?
General
