Need help?Do you have a question about the Yamaha MR1642 and is the answer not in the manual?
General| Type | Analog Mixer |
|---|---|
| Channels | 16 |
| Aux Sends | 4 |
| Faders | 60mm |
| Microphone Inputs | 8 |
| Phantom Power | Yes |
| Built-in Effects | No |
Selects input source between LO-Z/HI-Z or TAPE jack.
Attenuates input signal by 20 dB to prevent overloading.
Adjusts input sensitivity for optimal level matching.
Indicates when the post-EQ signal is 3dB below clipping.
Controls for adjusting HIGH, MID, and LOW frequencies with MID FREQ sweep.
Determine signal level sent to AUX 1 and AUX 2 mixing busses.
Controls AUX 3 signal path and TAPE input selection for monitor mix.
Assigns channel signals to group busses 1-2 or 3-4.
Pans channel signal between assigned group busses or stereo buss.
Allows independent monitoring of selected channels via the monitor system.
Area above faders for labelling channels for easy identification.
Main level control for each input channel, setting the mix balance.
Adjust overall output levels of AUX mixes and monitor AUX signals.
Controls and assigns stereo AUX returns to group or stereo busses.
Pans group signals across the master stereo buss.
Allows independent monitoring of selected group signals.
Adjust overall level of group mix signals fed to outputs.
Controls monitor system level and selects monitor sources (CUE, AUX 3, ST).
Adjusts cue signal level and indicates active cue switches.
Delivers monitor signal to headphones.
XLR connector for talkback microphone input.
Controls talkback signal level; ON switch is momentary.
Assigns talkback signal to group, AUX, or stereo busses.
Adjust levels of left and right stereo buss signals to outputs.
Monitors signal levels on groups, AUX, CUE, and stereo busses.
Turns the console power ON or OFF.
Provides balanced XLR (LO-Z) and 1/4" phone (HI-Z) inputs for sources.
-10 dB RCA pin jack for line-level sources like tape recorders.
TRS jack for external signal processing between head amp and EQ stage.
Jacks delivering AUX mixes (+4 dB output) for external processors or systems.
Jacks for returning processed AUX signals (+4 dB input) to busses.
TRS jacks for inserting external gear into group signal paths.
Direct inputs to stereo busses, used for cascading consoles.
Direct inputs to group busses, used for cascading consoles.
Main outputs from group busses (+4dB XLR, -10dB RCA).
Main outputs from the monitor system.
Main outputs from the stereo buss (+4dB XLR, -10dB RCA).
Applies +48V phantom power to LO-Z/HI-Z input connectors.
Block diagram showing signal flow from input channels to stereo buss.
Diagram illustrating the signal path for AUX sends 1, 2, and 3.
Diagram showing the signal path for AUX returns.
Diagram illustrating the signal path for cue and monitor systems.
Guidance on connecting microphones and instruments to inputs.
Advice on connecting external gear to outputs and returns.
How to set input sensitivity using PAD and GAIN controls for optimal levels.
Guidance on using the 3-band EQ for tonal adjustment and sound shaping.
Illustrates a typical setup for a small multitrack recording system.
Shows a typical setup for a small sound reinforcement system.
Covers THD, frequency response, noise, gain, EQ, power, dimensions, and weight.
Detailed table of input terminal specifications including impedance, sensitivity, and levels.
Detailed table of output terminal specifications including impedance, levels, and connectors.
To Next Page
