Yamaha MT09 - Rear Brake System Checks; Clutch Operation Check; Throttle Grip Operation Check; Control Cables Check

For your safety – pre-operation checks
4-2
1
2
3
4
5
6
7
8
9
10
11
12
Rear brake
• Check operation.
• If soft or spongy, have Yamaha dealer bleed hydraulic system.
• Check brake pads for wear.
• Replace if necessary.
• Check fluid level in reservoir.
• If necessary, add specified brake fluid to specified level.
• Check hydraulic system for leakage.
6-21
Clutch
• Check operation.
• Lubricate cable if necessary.
• Check lever free play.
• Adjust if necessary.
6-19
Throttle grip
• Make sure that operation is smooth.
• Check throttle grip free play.
• If necessary, have Yamaha dealer adjust throttle grip free play and lubricate cable
and grip housing.
6-15, 6-26
Control cables
• Make sure that operation is smooth.
• Lubricate if necessary.
6-25
Drive chain
• Check chain slack.
• Adjust if necessary.
• Check chain condition.
• Lubricate if necessary.
6-23, 6-25
Wheels and tires
• Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
6-16, 6-18
Brake and shift pedals
• Make sure that operation is smooth.
• Lubricate pedal pivoting points if necessary.
6-26
Brake and clutch levers
• Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
6-27
Sidestand
• Make sure that operation is smooth.
• Lubricate pivot if necessary.
6-27
Chassis fasteners
• Make sure that all nuts, bolts and screws are properly tightened.
• Tighten if necessary.
—
ITEM CHECKS PAGE
B87-9-E0_1.book 2 ページ ２０１５年１２月１６日 水曜日 午前１０時２１分