Yamaha MX-630 - Page 8

Heavy-gauge speaker cords
First, unscrew and remove the plastic wire holders. Insert the stripped
ends of the speaker cords into the holders until they protrude from the
other side.
Splay the strands as shown; then screw the wire holders back on.
Z
Note: :
When inserting the stripped ends of the speaker cords as shown above,
make sure that at least 1/16 inch (1.6 mm) of insulation is inside the wire
holders (ie. no exposed wire is visible) and that no loose conductor wire
strands are protruding after the connection is made. To prevent speaker
wires from loosening, make sure that the wire holders are firmly screwed
in.
Banana plug connectors (except U.K. and Europe models) .
Banana Plug connections are also possible. Simply insert the Banana P
connector into the corresponding terminal. ..
ΜΧ-650
1.
Strip off about 10 mm (3/8 in.) of the insulation (leaving only the cor
wire) from the end of each speaker connection wire to be connected
to this unit. |
. Unscrew the knob (for the SPEAKER connection terminal to which the
speaker connection wire is to be connected) until the wire can be
inserted into the hole at the top of the rear part of the knob. Each
speaker connection wire should be inserted securely, taking care that
does not contact any other terminal. Then turn the knob to tighten tr
knob securely.
y
Red:
positive
(+)
Black: negative (+)
The speaker connection wires should |
no longer than necessary.