EasyManua.ls Logo

Yamaha P5000S - Specifications

Yamaha P5000S
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
P5000S/P7000S
SPECIFICATIONS
0 dBu=0.775 Vrms, Half Power=1/2 Power Output Level (Rated Power)
Power Output Level (Rated Power) 8 /STEREO
1 kHz 4 /STEREO
THD + N = 1% 8 /BRIDGE
8 /STEREO
20 Hz
20 kHz 4 /STEREO
THD + N = 0.1% 8 /BRIDGE
1 kHz 2 /STEREO
20 ms non-clip 4 /BRIDGE
P7000S
750 W
× 2
1100 W
× 2
2200 W
× 1
700 W
× 2
650 W
×
2 (European Model)
950 W × 2
1900 W
× 1
1600 W
× 2
3200 W
× 1
P5000S
525 W
× 2
750 W
× 2
1500 W
× 1
500 W
× 2
700 W
× 2
1400 W
× 1
1300 W
× 2
2600 W
× 1
Power Bandwidth Half Power 10 Hz
40 kHz (THD + N = 0.5 %)
Total Harmonic Distortion (THD + N) 4
8 /STEREO
0.1 %
20 Hz
20 kHz, Half Power 8 /BRIDGE
Frequency Response RL = 8 , Po = 1 W 0 dB, +0.5 dB,
1 dB f = 20 Hz 50 kHz
Intermodulation distortion (IMD) 4
8 /STEREO
0.1 %
60 Hz:7 kHz, 4:1, Half Power 8 /BRIDGE
Channel Separation Half Power RL = 8 1 kHz
70 dB
Vol. max input 600 shunt
Residual Noise Vol. min. 20 Hz
20 kHz (DIN AUDIO)
70 dBu
SN Ratio 20 Hz
20 kHz (DIN AUDIO) 104 dB
Damping Factor RL = 8 , 1 kHz
350
Sensitivity (Vol. max.) Rated Power 8 +8 dBu
103 dB
+6 dBu
Voltage Gain (Vol. max.) 32.1 dB
Input Impedance 30 k/balanced, 15 k/unbalanced
Controls Front Panel POWER switch (Push on/Push off)
Two 31-step Volume control knobs (one per ch)
Rear Panel MODE switch (STEREO/PARALLEL/BRIDGE)
Two FILTER switches (SUBWOOFER/LOW CUT/OFF)
Two fc knobs (25 to 150 Hz)
YS Processing switch (ON/OFF)
Connectors INPUT XLR-3-31 jacks (one per ch)
1/4-inch TRS phone jacks (one per ch)
OUTPUT Speakon jacks (one per ch)
5-way binding posts
1/4-inch phone jacks (one per ch)
Indicators POWER 1 (Green)
PROTECTION 1 (Red)
TEMP
1 (Red) (heatsink temp 85
CLIP 2 (Red)
SIGNAL 2 (Green)
YS Processing 1 (Yellow)
Load protection POWER switch ON/OFF muting
DC-fault power supply
shutdown
Amp. protection
Temp. detection (heat sink temp 90 VI limiter (RL 1 )
Limiter
Comp: THD 0.5 %
Cooling Dual variable-speed fan
Power Requirements United States & Canada 120 V, 60 Hz
Europe 230 V, 50 Hz
Australia 240 V, 50 Hz
Power Consumption Idling 35 W
1/8 output power, 4 700 W
Maximum output, 4 4000 W
35 W
550 W
3000 W
Dimensions (W
× H × D) 480 88 456 mm
Weight 12 kg
Included Accessories Security cover (with a hex wrench), Owner s Manual
Ω
Ω
× ×

Related product manuals