Yamaha R3 2021 - Shift indicator light control mode

Instrument and control functions
4-8
4
fuel consumption measurement units,
push the “SELECT” button until the
measurement units change.
z “AVE_ _._ km/L”: the average dis-
tance that can be traveled on 1.0 L
of fuel.
z “AVE_ _._ L/100 km”: the average
amount of fuel necessary to travel
100 km.
z “AVE_ _._ MPG”: the average dis-
tance that can be traveled on
1.0 Imp.gal of fuel.
TIP
z To reset the display, push the
“RESET” button until it resets.
z After resetting, “_ _._” is shown
until the vehicle has traveled some
distance.
EAU87960
Shift indicator light control mode
This mode cycles through 4 control
functions in the order listed below.
z Shift indicator light on / flash / off
z Shift indicator light on r/min
z Shift indicator light off r/min
z Shift indicator light brightness
To set the shift indicator light on /
flash / off
1. Turn the vehicle off.
2. Push and hold the “SELECT” but-
ton.
3. Turn the vehicle on, and then re-
lease the “SELECT” button after 5
seconds.
4. Push the “RESET” button to select
one of the following flashing pat-
tern settings:
z On setting: the shift indicator
light will come on when the
set engine speed is reached.
This setting is selected when
the shift indicator light stays
on.
z Flash setting: the shift indica-
tor light will flash when the set
engine speed is reached. This
setting is selected when the
shift indicator light flashes 4
times per second.
z Off setting: the shift indicator
light is deactivated. This set-
ting is selected when the shift
indicator light flashes once
every 2 seconds.
5. Push the “SELECT” button to con-
firm the setting. The control mode
changes to the shift indicator light
on r/min setting function.
To set the shift indicator light on r/min
The shift indicator light can be set be-
tween 7000 r/min and 13500 r/min.
From 7000 r/min to 12000 r/min, the in-
1. Shift indicator light “ ”
2. Brightness level display
MPH
1
2
UB5L12E0.book Page 8 Wednesday, March 25, 2020 9:59 AM