Yamaha RM602 - Front Panel Controls; Input Section Controls

THE CONTROLS AND THEIR FUNCTIONS
ke TAPE N TAPE OUT — AUXIN STEREO OUT— “STEREO MONITOR
INSEAT ОЛ
RECORDING MIXER
MODEL RM602
FRONT
PANEL
nn
—
E
=
Ф
|
®
о
Өө
Ө
INPUT SECTION
1. INPUT SELECTOR
This four-position input selector sets the input sensitivity
of the six channel inputs to —50, -35 or —20 dB. Note
also that the fourth position on channels 1—4 is labelled
“TAPE”, while the same position on channels 5 and 6
are labelled “PHONO L” and “PHONO R”. When the
TAPE position on inputs 1—4 is selected, the corre-
sponding TAPE IN input (see rear panel) is selected as
input rather than the channel INPUT. When the PHONO
position on inputs 5 and/or 6 is selected, the correspon-
ding phono input channel (PHONO Г or PHONO В) is
selected.
The -50/-35/-20 dB sensitivity positions on the input
selector allow you to match the input sensitivity of each
input channel to match the source — e.g. microphone,
electronic music instruments or line level sources. This
allows you to use just about any source on any input
channel without overloading the mixer's electronics. Most
microphones — especially dynamic types — will work best
with the —50 dB input setting. Some high-output con-
denser and electret mics may require the —35 dB setting.
PRECAUTIONS
* Be sure to turn down all faders when making input/
output connections.
* Do not expose the RM602 to direct sunlight or other
sources of heat such as radiators, etc.
е Irreparable damage may result from opening the
RM602 cabinet or attempting to alter the internal
circuitry.
* Avoid dropping your RM602 or subjecting it to any
type of shock, as impaired performance may result.
e Do not attempt to clean the RM602 with benzine or
other soivents, as these may cause discoloration or
deformation of the cabinet. Clean the unit with a soft,
dry cloth. ^