RX-E100
RX-E100
9
Step
1
2
3
4
5
6
Adjustment item
Adjustment of
discriminator balance
Verification of monau-
ral distortion
Verification of stereo
distortion
Verification of sensi-
tivity
Verification of
Separation
Verification of auto
tuning
Reception
frequency
98.1MHz
* (A-1)
98.1MHz
* (A-1)
98.1MHz
* (A-1)
Tuning mode
should be
AUTO.
88.1MHz
* (A-6)
98.1MHz
* (A-1)
106.1MHz
* (A-7)
98.1MHz
* (A-1)
98.1MHz
Signal (ANT IN)
FM ANT (75Ω)
98.1MHz ± 5kHz
70dBµ
MONO
1kHz,
100% modulation
FM ANT (75Ω)
98.1MHz
70dBµ
MONO 1kHz,
100% modulation
FM ANT (75Ω)
98.1MHz
70dBµ
Stereo L or R
1kHz,
100% modulation
FM ANT (75Ω)
88.1MHz
98.1MHz
106.1MHz
MONO 1kHz
Modulation off
FM ANT (75Ω)
98.1MHz
70dBµ
Stereo L or R
1kHz,
100% modulation
FM ANT (75Ω)
98.1MHz
23dBµ
Stereo L or R
1kHz,
30% modulation
Adjusted
point
L10
Test point
Both ends of R24
(Between pin 26
and pin 28 of IC1)
REC OUT L, R
REC OUT L, R
ANT (75Ω)
REC OUT L, R
Rating
DC 0V±50mV
– 36dB or less
– 29dB or less
• STEREO indicator should
light.
1)Set the tuning mode to
MAN’L MONO.
(Muting OFF)
2) S/N should be 30dB at each
frequency of 88.1MHz,
98.1MHz, and 106.1MHz.
3)
Check to ensure that the volt-
age at the ANT terminal is
6dBµ (14.25dBf) or less.
(A, B, G only : 10dBµ or less)
22dB or more
• Automatic reception
should be available when
the tuning key is moved UP
and DOWN.
• The stereo indicator should
light.
• Audio muting should be ap-
plied during tuning.
*:Execution of FACTORY PRESET (Refer to page 7.) will facilitate setting reception frequency for adjustment.
To Next Page
Loading...
