Yamaha RX-V596 - Specifications

54
SPECIFICATIONS
AUDIO SECTION
• Minimum RMS Output Power
20 Hz to 20 kHz, 0.06% THD, 8 ohms
Main L/R, Center, Rear L/R ....................................... 100 W*/70 W
1 kHz, 0.09% THD, 8 ohms
Main L/R, Center, Rear L/R ....................................... 110 W*/80 W
• Maximum Output Power (EIAJ)
1 kHz, 10% THD, 8 ohms ........................................................ 105 W
• DIN Standard Output Power
1 kHz, 0.7% THD, 4 ohms ....................................................... 110 W
• IEC Output Power
1 kHz, 0.06% THD, 8 ohms ....................................................... 75 W
• Dynamic Power (IHF)
8/6/4/2 ohms ..................... 130/150/190/240 W*, 90/110/135/160 W
• Damping Factor
20 Hz to 20 kHz, 8 ohms ................................................................ 80
• Frequency Response
CD etc. to MAIN L/R ................................. 10 Hz to 100 kHz, –3 dB
• Total Harmonic Distortion (20 Hz to 20 kHz)
CD etc. to MAIN L/R, 1/2 power, 8 ohms .............................. 0.06%
• Signal-to-Noise Ratio (IHF-A Network)
CD etc. to MAIN L/R
(150 mV, Input Shorted) ........................................................ 99 dB
(250 mV, Input Shorted) ....................................................... 103 dB
• Residual Noise (IHF-A Network)
MAIN L/R .............................................................................. 150 µV
• Input Sensitivity/Impedance
CD etc. ................................................................. 150 mV/47 k-ohms
EXT. DECODER......................................... 150 mV/40 – 47 k-ohms
• Output Level/Impedance
REC OUT ........................................................... 150 mV/1.2 k-ohms
PRE OUT ............................................................... 2.1 V/1.2 k-ohms
SUBWOOFER ....................................................... 4.0 V/1.2 k-ohms
PHONES ................................................................. 0.34 V/560 ohms
• Channel Separation (Vol. –30 dB)
CD etc. (Input 5.1 k-ohms Terminated, 1 kHz/10 kHz)
..................................................................................... 60 dB/45 dB
• Tone Control Characteristics
BASS: Boost/cut .......................................................... ±10 dB/50 Hz
TREBLE: Boost/cut ................................................... ±10 dB/20 kHz
* for U.S.A. and Canada models
VIDEO SECTION
• Video Signal Type ...........................................................NTSC or PAL
• Video Signal Level ...................................................... 1 Vp-p/75 ohms
• Signal-to-Noise Ratio .................................................................. 50 dB
• Monitor Out Frequency Response .................... 5 Hz to 10 MHz, –3 dB
FM SECTION
• Tuning Range .................................... 87.5/87.50 to 107.9/108.00 MHz
• Usable Sensitivity (DIN)
Mono (S/N 26 dB) ................................................................... 0.9 µV
Stereo (S/N 46 dB) ................................................................... 28 µV
• Selectivity (two signals, 40 kHz Dev., ±300 kHz) ...................... 55 dB
• Signal-to-Noise Ratio (Mono/Stereo)
DIN ................................................................................. 75 dB/69 dB
IHF ................................................................................. 81 dB/75 dB
• Harmonic Distortion (1 kHz)
Mono/Stereo ........................................................................ 0.1/0.2%
• Stereo Separation (1 kHz) ........................................................... 48 dB
• Frequency Response ........................................ 20 Hz to 15 kHz, ±1 dB
• Antenna Input ......................................................75 ohms, Unbalanced
AM SECTION
• Tuning Range ............................................530/531 to 1,710/1,611 kHz
• Usable Sensitivity ................................................................. 300 µV/m
• Signal-to-Noise Ratio ................................................................... 52 dB
• Antenna ........................................................................... Loop antenna
GENERAL
• Power Supply
[U.S.A. and Canada models] .................................. AC 120 V, 60 Hz
[Europe, U.K. and Singapore models] .................... AC 230 V, 50 Hz
[Australia model] ..................................................... AC 240 V, 50 Hz
[China model] ......................................................... AC 220 V, 50 Hz
[General model]............................. AC 110/120/220/240 V, 50/60 Hz
• Power Consumption ...................................................... approx. 310 W
• Power Consumption (standby mode) .................................approx. 1 W
• AC Outlets (100 W max. total)
[U.K. and Australia models] ..................................... 1 (SWITCHED)
[Other models].......................................................... 2 (SWITCHED)
• Dimensions (W x H x D)
..................... 435 x 151 x 391 mm (17-1/8’’ x 5-15/16’’ x 15-3/8’’)
• Weight ......................................................................... 11.2 kg (25 lbs.)
• Accessories ................................................................ AM loop antenna
.......................................................................... Indoor FM antenna
.....................75-ohm/300-ohm antenna adapter (U.K. model only)
........................ Antenna adapter (U.S.A. and Canada models only)
.................................................................................Remote control
........................................................................................... Batteries
Specifications are subject to change without notice.
0110V596(UCA)50-56_EN 9/29/0, 10:05 AM54