first, and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
G The drive chain cannot be disas-
sembled.
7. While supporting the brake cali-
per bracket, pull the wheel axle
out, and then remove the wheel.
NOTICE: Do not apply the bra-
ke after the wheel has been
removed together with the bra-
ke disc, otherwise the brake
pads will be forced shut. [ECA11071]
EAUB1450
To install the rear wheel
1. Install the wheel and the brake
caliper bracket by inserting the
wheel axle from the left-hand
side.
TIP
G Make sure that the slot in the bra-
ke caliper bracket is fit over the
retainer on the swingarm.
G Make sure that there is enough
space between the brake pads
before installing the wheel.
2. Install the drive chain onto the
rear sprocket.
3. Install the axle nut, and then
lower the rear wheel so that it is
on the ground.
4. Adjust the drive chain slack. (See
page 6-23).
5. Apply the rear brake several
times, and then tighten the axle
nut to the specified torque.
EAU25871
Troubleshooting
Although Yamaha motorcycles recei-
ve a thorough inspection before ship-
ment from the factory, trouble may
occur during operation. Any problem
in the fuel, compression, or ignition
systems, for example, can cause poor
starting and loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcy-
cle require any repair, take it to a
Yamaha dealer, whose skilled techni-
cians have the necessary tools, expe-
rience, and know-how to service the
motorcycle properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
EWA15141
When checking the fuel system, do
not smoke, and make sure there
are no open flames or sparks in the
To Next Page
Loading...
Need help?
General
