Operation
56
Make sure that no one is near the out-
board motor before performing this
check.
1. Check the power trim and tilt unit for fluid
leakage.
2. Operate each of the power trim and tilt
switches on the bottom cowling and re-
mote control lever to check that all
switches work.
3. Tilt the outboard motor up and check
that the tilt rod and trim rods are extend-
ed completely.
4. Check that the tilt rod and trim rods are
not corroded or damaged.
5. Tilt the outboard motor down. Check
that the tilt rod and trim rods operate
smoothly.
EMU36585
Battery
Check the battery’s charge. If your boat is
equipped with a Yamaha digital speedome-
ter, the voltmeter and low battery alert func-
tions will help you monitor the battery’s
charge. A battery in good condition will pro-
vide a minimum of 12 volts. Check that the
battery connections are clean, secure and
covered by insulating covers. The electrical
connections of the battery and cables must
be clean and properly connected or the bat-
tery will not start the engine.
If the battery needs charging, consult your
Yamaha dealer or the battery manufacturer’s
instructions.
1. Power trim and tilt switch
1. Power trim and tilt switch
1. Tilt rod
2. Trim rod
U6EH36E0.book Page 56 Monday, December 10, 2018 9:33 AM
©2020 Yamaha Motor Corporation
To Next Page
Loading...
Need help?
General
