Operation
69
EMU40712
Procedure for shallow water cruising
1. Move the remote control lever to the
neutral position.
2. Push the “ ” (up) side of the power trim
and tilt switch to tilt the outboard motor
up slightly to the desired position.
WARNING! Using the power trim and
tilt switch on the bottom cowling while
the boat is moving or engine is on
could increase the risk of falling over-
board and could distract the operator,
increasing the risk of collision with an-
other boat or an obstacle.
[EWM01851]
3. To return the outboard motor to the nor-
mal running position, push the “ ”
(down) side of the power trim and tilt
switch to tilt the outboard motor down
slowly.
EMU28196
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged. Also rinse the
outside of the outboard motor with fresh wa-
ter.
Cruising in muddy, turbid, or acidic water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
(see page 21) if you use the outboard motor
1. Cooling water inlet
1. Power trim and tilt switch
1. Power trim and tilt switch
U6EH36E0.book Page 69 Monday, December 10, 2018 9:33 AM
©2020 Yamaha Motor Corporation
To Next Page
