For your safety – pre-operation checks
5-2
5
Drive chain
• Check chain slack.
• Adjust if necessary.
• Check chain condition.
• Lubricate if necessary.
7-21,
7-22
Drive sprocket
• Check the drive sprocket nut torque.
• Tighten if necessary.
—
Wheels and tires
•Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
• Check for loose spokes and tighten if necessary.
7-14,
7-16
Shift pedal
• Make sure that operation is smooth.
• Check the shift pedal bolt torque.
• Correct if necessary.
7-18
Brake pedal
• Make sure that operation is smooth.
• Lubricate pedal pivoting point if necessary.
7-24
Brake and clutch le-
vers
• Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
7-24
Steering
• Check that the handlebar can be turned smoothly and
has no excessive play.
7-26
Front fork and rear
shock absorber as-
sembly
• Check that they operate smoothly and there is no oil
leakage.
4-9,
4-11,
4-12,
7-26
Chassis fasteners
• Make sure that all nuts, bolts and screws are properly
tightened.
• Check all cotter pins for damage and correct install-
ment.
• Tighten or replace if necessary.
—
Moving parts and ca-
bles
• Check the control cables for damage.
• Check that the control cables move smoothly.
• Check that the control cables are not caught when the
handlebars are turned or when the front forks travel up
and down.
• Lubricate moving parts and cables if necessary.
7-23,
7-24,
7-25,
7-25
Exhaust system
• Check that the exhaust pipe and muffler are tightly
mounted and have no cracks.
• Check for leakage.
—
Engine stop switch • Check operation. 4-1
Ignition system • Check that all leads and cables are properly connected. 7-6
ITEM CHECKS PAGE
UBR811E0.book Page 2 Thursday, March 21, 2019 10:27 AM
To Next Page
Loading...
