Periodic maintenance and adjustment
7-8
7
6. Refill with the specified amount of
the recommended transmission
oil.
ECA10453
In order to prevent clutch slip-
page (since the transmission oil
also lubricates the clutch), do
not mix any chemical additives.
Do not use oils with a diesel
specification of “CD” or oils of a
higher quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
Make sure that no foreign mate-
rial enters the transmission.
7. Check the O-ring for damage, and
replace it if necessary.
8. Install and tighten the transmis-
sion oil filler cap and its O-ring.
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
EAU20071
Coolant
The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
EAUM1296
To check the coolant level
1. Place the vehicle on a level surfa-
ce and hold it in an upright posi-
tion.
The coolant level must be
checked on a cold engine since
the level varies with engine tem-
perature.
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Remove the radiator cap and
check the coolant level in the radi-
ator. WARNING! Never attempt
to remove the radiator cap
when the engine is hot.
[EWA10382]
Tightening torque:
Transmission oil drain bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Recommended transmission oil:
Motor oil SAE 10W-30 type SE or
higher or Gear oil SAE 85W GL-3
Oil change quantity:
0.50 L (0.53 US qt, 0.44 Imp.qt)
1. Radiator cap
UBR811E0.book Page 8 Thursday, March 21, 2019 10:27 AM
To Next Page
Loading...
