Need help?Do you have a question about the Yanmar 3 QM 30 and is the answer not in the manual?
Use high-grade diesel oil and keep fuel cap clean.
Choose oil viscosity based on ambient temperature; avoid mixing oils.
Run in new engines for 50 hours without strain; retighten bolts after break-in.
Fill fuel tank, open fuel cock, and check fuel injection.
Check oil level in crankcase/clutch case and lubricate parts like starter chain.
Instructions for starting the engine using the hand crank.
Steps for starting the engine using the electrical starter.
Check fuel level and add fuel before gauge shows emptiness.
Check that the lubrication oil pressure warning lamp is out.
Idle engine, then use speed control to stop; do not use decompression lever.
Regular checks and refills for fuel oil, including filter elements and injection.
Regular checks and changes for lubricating oil, including oil level and strainers.
Regular checks for cooling water circulation, impeller, thermostat, and anticorrosive zinc.
To Next Page
General
