EasyManua.ls Logo

Yanmar 3GMD - Page 67

Yanmar 3GMD
240 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION, LUBRICATION, MAINTENANCE AND TUNE-UP
61
Transmission Oil Level
Check
Check the transmission oil level on a weekly basis.
I. With the boat at rest in
the water and the engine off, un-
screw the dipstick (Figure 39, typical). Wipe it with a
clean rag or paper towel. Reinsert the dipstick, but do not
screw it in. Pull out the dipstick and read the oil level on
the dipstick.
2. Add oil,
if
necessary, through the dipstick hole so the
oil level reaches the full mark on the dipstick. Use the oil
recommended in the preceding section.
Daily
Weekly
Every 50
hours
Every 100 hours
Every 250 hours
Every 300 hours
Every 500
hours
Every 1500
hours
Every 2000
hours
Annually
Ambient
Temperature
Below 50° F (10° C)
50° - 68°
F W -20° C)
68° - 95°
F (20° - 35° C)
Above 95°
F (35° C)
Model
1GM,1GM10
2GM,2GM20
3GM,3GM30
3HM,3HM35
Table
1
MAINTENANCE
SCHEDULE
Check fuel level
Check engine oil level
Check battery
Check air
filter
Check transmission oil level
Check
drive
belt tension
Check electrical wiring
Clean fuel filter
Change engine oil
Drain fuel
tank
Replace air filter element
Replace fuel filter element
Change transmission oil
Replace engine oil filter
Adjust
engine valves
Inspect thermostat
Inspect seawater
pump
Replace thermostat
Replace freshwater (closed system) antifreeze
Table
2
ENGINE
OIL
VISCOSITY
Oil
viscosity
1
OW,
20W or 20/20W
20 or 20/20W
30 or 40
50
Table
3
ENGINE
OIL
CRANKCASE
CAPACITY
Oil
capacity
1.4 qt. (1.3 L)
2.1 qt. (2.0 L)
2.8 qt. (2.6 L)
5.7 qt. (5.4 L)

Other manuals for Yanmar 3GMD

Related product manuals