13-4
13. MAINTENANCE
Lx410/450/490 Operator's Manual
(Specifications and design are subject to change without prior notice for improvement.)
3. Lubricants
No. Locations Capacities Lubricants
1 Fuel Approximately 11.9 US gal (45 L)
No.2-D diesel fuel
No.1-D diesel fuel if temperature is below 14°F
(-10°C)
2 Coolant* Approximately 5.83 qt. (5.5 L)
High Quality Permanent Type Antifreeze
(Ethylene Glycol with corrosion and rust
inhibitor chemicals)
Coolant Mixture Ratio
Distilled Water 50% : Antifreeze 50%
3
Engine crankcase
(with filter)
Approximately 5.62 qt. (5.3 L)
API Service Classifications CF or higher
SAE 10W-30 or SAE 10W-40
4
Transmission
hydraulic oil
Approximately 8.5 US gal (32 L) Hydraulic/Transmission Fluid (TF 500)
5 Front axle gear oil Approximately 2.3 US gal (8.8 L) SAE 80W-90 gear oil
6
Greasing No. of Greasing points Lubricants Type of grease
Front axle pivot 2
Until grease overflows
General all purpose
grease NLGI grade
No.2
Tie rod end 2
Lift link 1
*NOTE
● Immediately after purchasing the tractor:
• adjust the coolant mixture ratio of the coolant and water to suite the local climate
• the preceding practice assists in making the tractor function efficiently
● The coolant can remain unchanged for a period of 2 years:
• if during the period the tractor is operated for less than 1200 hours
• if the tractor is operated for more than 1200 hours during the period, the coolant has to be replaced during
flushing of the system
● After pouring the coolant, run the engine for a short period to mix the two fluids thoroughly.
To Next Page
Loading...
