14. PERIODIC SERVICE
14-17
Lx410/450/490 Operator's Manual
■ Grease Fittings
(General all purpose grease NLGI grade No. 2)
1. Lubricate the Grease Fittings on the
Tie Rod
Extremely Wet or Muddy Conditions
Lubricate the grease fittings once every 10 operating
hours or once a day.
All Other Conditions
Lubricate the grease fittings once every 50 operating
hours.
(A) Right tie rod end (grease fitting)
(B) Left tie rod end (grease fitting)
2. Check and Lubricate the Front Axle
Pivot
Extremely Wet or Muddy Conditions
Lubricate the grease fittings once every 10 operating
hours or once a day.
All Other Conditions
Lubricate the grease fittings once every 50 operating
hours.
(A) Front axle pivot pin grease fitting (front)
IMPORTANT
● Use the recommended greases by Yanmar.
• the preceding procedure prevents premature
wear or failure of the parts and components
● The recommended greases by Yanmar perform
efficiently in an average ambient temperature
range from -20 to +275 °F (-29 to +135 °C).
● When intending to operate the tractor outside the
preceding temperature range:
• contact YOUR LOCAL YANMAR TRACTOR
DEALER for the applicable special purpose
greases
To Next Page
Loading...
