Yanmar Lx410 - Point Hitch and Drawbar; Point Hitch; Use the 3-Point Hitch Control Lever

10-1
10. 3-POINT HITCH AND DRAWBAR
Lx410/450/490 Operator's Manual
10.3-POINT HITCH AND DRAWBAR
(A) Top link
(B) Top link hook
(C) Left arm, Right arm
(D) Lift Link right
(E) Stabilizer
(F) Lower links
(G)Drawbar
(H) Lift Link left
(I) Power Take Off (PTO) shaft
(J) Power Take Off (PTO) shield
■ Use the 3-Point Hitch Control Lever
1. Use the 3-point hitch control lever to raise and
lower the implement attached to the 3-point hitch.
● When there is a 3-point hitch-mounted
implement:
• always install an appropriate weight to the
front of the tractor
● During transportation:
• place the 3-point hitch control lever in the
raised position
• lock the 3-point hitch control lever with the
position stop knob for the 3-point hitch
control lever
● Do not fully close the hydraulic flow control/
stop knob in order to keep any implements in
the raised position while the tractor is
traveling.
• completely closing the hydraulic flow
control/stop knob can damage the hydraulic
lift circuit
● Only use implements that are designed for
use with the 3-point hitch.
● Always use approved implements with the 3-
point hitch.
● Contact YOUR LOCAL YANMAR TRACTOR
DEALER for technical assistance.
! WARNING
1. 3-Point Hitch
NOTE
● The 3-point hitch delivered with the tractor is a
Category 1.
NOTE
● The 3-point hitch control lever is labeled 1 to 6.
● The numbers:
• for reference purposes only
• does not indicate any exact height position for
the implement that is attached to the 3-point
hitch
● The lower the number, the closer the lower links
is to the ground.
38 P1080928
(A) (B)
(C)
(D)
(E)
(F)
(G)
(F)
(E)
(H)
(I)
(C)
(J)