Yanmar Lx410 - Use the Lower Links (and Top Link as Needed)

10-3
10. 3-POINT HITCH AND DRAWBAR
Lx410/450/490 Operator's Manual
(A) Hydraulic flow control/stop knob
(a) Knob turned counterclockwise:
• increases the rate of drop speed
• unlocks the hydraulic lift
(b) Knob turned clockwise:
• decreases the rate of drop speed
Knob turned clockwise until the knob stops
turning:
• locks the hydraulic lift
■ Use the Lower Links (and Top Link as
Needed)
1. Slowly back up the tractor into a position where
the lower links are aligned with the implement lift
brackets.
2. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
3. Chock all the tires safely and securely.
4. Connect the lower links to the implement.
5. As necessary, unhook the top link from the top
link hook, and connect to the implement.
6. Use lynch pin to secure the implement.
(A) Top link
(B) Lower Link
Avoid injury!
● Always be extremely careful when backing up
the tractor.
● Always clear the surrounding area of the
tractor from bystander/s and obstacle/s
before starting to back up.
● While backing up, always watch for
bystander/s and obstacle/s along the way.
● Engage the parking brake securely, for
details, see "6. Lock and Set the Parking
Brake" on page 7-4 before getting in between
the tractor and the implements to be installed
or removed.
● Check for any interference between the
implement and the tractor and/or driveline
separation:
• whenever a Power Take Off (PTO) driven
implement is installed to the 3-point hitch
35 P1080310
(A)
(b)
(a)
! WARNING
NOTE
● Always remove the drawbar to prevent
interference with the implements to be mounted.
NOTE
● Whenever the top link is not used, always place
the top link in the top link hook.
38 P1080928
(A)
(B)