9-4
9. POWER TAKE OFF (PTO) SYSTEM
SA221/324/424 Operation Manual
■ Disengage Power Take Off (PTO) (with
the operator on the operator seat)
1. Idle the engine speed.
2. Push down Power Take Off (PTO) switch to OFF
position.
(A) Power Take Off (PTO) switch
(a) OFF position
(b) ON position
Use Power Take Off (PTO) with the operator out of
the operator seat.
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking
the Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
(A) Parking brake lock lever
4. Move the range shift lever to the N (neutral)
position (SA324/424) and Power Take Off (PTO)
switch to OFF position.
5. Sit on the operator seat.
6. Start the engine.
7. Pull up Power Take Off (PTO) switch to ON
position.
(A) Power Take Off (PTO) switch
2. Install an Implement to Power
Take Off (PTO) Driveline
Avoid injury!
● Before installation of an implement to Power
Take off (PTO) driveline,
• make sure that the tractor is stopped
• make sure that Power Take Off (PTO) switch
is in the OFF position
IMPORTANT
● Observe the driveline manufacturer installation
instructions for:
• driveline mounting angle
• length of the overlaps on the driveline shafts
● An incorrectly installed implement can promote
wear of the driveline and/or damage the tractor.
(a) (b)
NOTE
●To operate the Mid-/Power Take Off (PTO). The
operator must be sitting on the operation seat.
SA221_324_424_OperatorsManual.book 4 ページ ２０１８年６月４日 月曜日 午後５時１９分
To Next Page
Loading...
