PERIODIC MAINTENANCE
SD60 Operation Manual 29
3. Align the splines and insert the
propeller on the propeller shaft.
The propeller shaft must fit evenly on
the splines.
Figure 19
4. Wipe off excess grease.
Install the propeller shaft nut.
Figure 20
5. Place a block of wood between one of
the propeller blades and the hull.
Mount the special insert T2 on a
suitable torque wrench and insert into
the hole in the propeller nut and tighten
to a torque of 125 N·m.
Figure 21
6. Install the locking screw in the center.
Tighten the locking screw to a torque of
23 N·m.
Figure 22
SD60_OPM.book 29 ページ ２０１７年１２月８日 金曜日 午後３時６分
To Next Page
Loading...
