Yanmar SD60 - Page 40

TROUBLESHOOTING
36 SD60 Operation Manual
First of all check, whether all items of operating instructions have been complied with.
The following assists you in troubleshooting.
Symptom Possibly caused by Remedy
1. High oil temperature • Oil level high during operation
• Oil level low
• No water in cooling system
• Unknown
• Pump out oil to max. mark on dipstick
• Add oil
• Check cooling system and repair
• Consult authorized Yanmar marine
distributor or dealer
2. Oil on sail drive
housing
• Loose screws
• Loose screw connections
• Loose dipstick
• Oil level high during operation
• Unknown
• Tighten to specification
• Tighten, replace
• Tighten, replace
• Pump out oil to max. mark on dipstick
• Consult authorized Yanmar marine
distributor or dealer
3. Shifts hard • Selector control
•Linkage
• Unknown
• Consult authorized Yanmar marine
distributor or dealer
• Adjust
• Consult authorized Yanmar marine
distributor or dealer
4. Slow engagement • Selector control
•Linkage
• Unknown
• Consult authorized Yanmar marine
distributor or dealer
• Adjust
• Consult authorized Yanmar marine
distributor or dealer
5. No movement of the
boat
• Selector control
• Improper selector position
• Propeller missing
• Propeller shaft broken
• Sail drive malfunction
• Engine malfunction
• Consult service station
• Adjust
• Replace
• Consult authorized Yanmar marine
distributor or dealer
• Consult authorized Yanmar marine
distributor or dealer
• Consult authorized Yanmar marine
distributor or dealer
SD60_OPM.book 36 ページ ２０１７年１２月８日 金曜日 午後３時６分