Yanmar YDG Series - Engine Control Lever; Spark Arrester

PRODUCT OVERVIEW
YDG Operation Manual
33
Engine Control Lever
Note: If using the stop lever to shut-down the
engine be sure to return the key switch to
the OFF position to prevent discharging
of the battery.
The engine control lever (Figure 11, (1)) is moved
to the run position (Figure 11, (2)) for generator
operation. To stop the generator turn the key switch
to the OFF position, or push down on the stop lever
(Figure 11, (3)) and the control lever,
(Figure 11, (1)) which is spring-loaded, will move
back to the stop position.
Figure 11
Spark Arrester
A spark arrestor (Figure 12, (1)) is installed in the
outlet port of the muffler. A spark arrester is
required if using the generator in a national forest
and other designated state and local areas. Check
local codes.
The spark arrester needs periodic cleaning. A dirty
spark arrester reduces engine output and
increases fuel consumption. It also makes starting
difficult. See Check Spark Arrester on page 56.
Figure 12
CAUTION
NEVER attempt to adjust the low or high
idle speed limit screw. This may impair
the safety and performance of the
machine and shorten its life. If
adjustment is ever required, contact
your authorized Yanmar industrial
engine dealer or distributor.
0000045en
RUN
STOP
(
2
)
(
3
)
(
1
)
0002443A
(1)
(4)
(3)
(2)
0001567A